Qaromashop Expansion Kit
Qaromashop Expansion Kit
The Qaromashop Expansion Kit provides everything you need to add a coil to your setup! Whether you are converting over, or adding to your existing lineup, you are sure to enjoy the end game experience with Qaromashop products!
If you already have a setup but with an incompatible coil, make sure to pick up an adapter! Already have a compatible PID? It’s as simple as plug and play. The expansion package comes fully assembled and ready for use right away. Install and inhale, that easy!
Everything you need is Included. Housing of choice , rubies , coil , handle and an optional jade stand.
Instructions / Installation
Plug in PID to an outlet
Plug in coil and set in the stand
Turn PID on and set it to 800, only use the up and down arrows, let the coil burn off factory oils for 10 minutes, and turn it off when the timer is up and allow it to cool.
While that's going on, clean and thoroughly rinse the housing, rubies, and bowls with isopropyl alcohol. Then dry completely.
By this time your coil should be cooled to the touch.
You should now attach your handle, you can use electric tape around the very bottom metal part to make a tighter fit.
Fill the your housing of choice to the top of the chamber, you can pile a few extra on top if you wish and remove as necessary to completely close the head, when fully assembled it should sound like a maraca.
Place the coil into the head and screw the top on snug, don't over tighten it.
Plug assembled unit into the PID controller and set the head in the stand.
Turn on the PID, and set your temperature to the 500-520 range to start, adjust up or down accordingly later on. Let the PID reach temperature, and then give it another 10 minutes to fully reach heat soak and you're good to go.
DONT DOs
-don’t use housing with empty ball chamber
-don’t tighten the coil on Qaroma housings
-don’t use at too high temps
-don’t leave on for extended periods